Slide and Turn System SF 35

  • Optimal panel guidance without guide arm when opening and closing
  • Height compensation profile with horizontal flange
  • Screw cap with cover clip
  • Height compensation profile with vertical flange
  • Completely stainless carriage system
  • Height compensation profile allows a height adjustment of up to 22 mm
  • Corner angle continuously adjustable for top track and height compensation profile
  • Turn knob
  • Screwed glass; glass thickness 6, 8 or 10 mm possible

System Information

  • Framed slide and turn system
  • Non-thermally insulated aluminum profiles with insulated glass
  • Option of flush or weathered bottom track
  • The flush bottom track is particularly suitable for use in "Barrier-free dwellings"
  • according to DIN 18 025
  • Panels can be stacked open either internally or externally
  • Opening of panels by sliding to one side or to both sides
  • Optionally with or without lateral vertical frame profiles
  • Height variations can be compensated by a height compensation profile
  • Airborne sound insulation Rw = 30 dB according to DIN EN ISO 140-3
  • Measurement of deflection class 3 according to DIN EN 12211/12210 (20 mm glass(4/12/4))
  • Repeated pressure/wind suction class 3 according to DIN EN 12211/12210 (20 mm glass(4/12/4))
  • Safety test class 3 according to DIN EN 12211/12210 (20 mm glass(4/12/4))
  • All fittings are concealed within the profiles
  • Low-maintenance, non-corroding and failsafe fittings
  • Inside and/or outside locking possible
  • Locking and unlocking via user-friendly flat handle
  • Turn panel may be equipped with a profile cylinder lock to prevent unauthorized opening
  • Top running, maintenance-free horizontal running assemblies, each equipped with two rollers
  • The running assemblies feature each three smooth-running needle bearings and two carbon fibre reinforced polyamide rollers
  • Running assemblies out of stainless steel metal components
  • Low-noise, low-wear, heat and cold resistant running surfaces
  • Running assemblies pivot at any angle between 90° and 180°
  • Tongue and groove system between the panels
  • Brush gaskets are fitted horizontally at the top and bottom on the inside and outside
  • Lower and upper brush gaskets are attached to the panel frames and not to the guide rail
  • Insulated glass of 18 or 20 mm possible
  • Subsequent replacement of panels without difficulty
  • Unpressurised drainage via inclined floor construction
  • Integrated water drainage channel on inside of bottom track (option)
  • End-caps for lateral sealing of bottom track

You can choose from a large number of colours on the SUNFLEX colour wheel.