Slide and Turn System SF 30

  • Optimal panel guidance without guide arm when opening and closing
  • Solid metal-reinforced locking slide for increased resistance to wind load
  • Turn knob
  • Height compensation profile allows a height adjustment of +/- 5 mm
  • Additional stability through tongue and groove joint between the end caps
  • Adjustable profile end cap for height compensation profile and bottom track

System Information

  • Standing slide and turn system
  • Non-thermally insulated aluminum profiles with tempered safety glass
  • The flush bottom track is particularly suitable for use in „Barrier-free dwellings“ according to DIN 18 025
  • Panels can be stacked open either internally or externally
  • Opening of panels by sliding to one side or to both sides
  • Height variations can be compensated by a height compensation profile
  • All fittings are concealed within the profiles
  • Low-maintenance, non-corroding and failsafe fittings
  • Inside and/or outside locking and unlocking possible
  • Locking and unlocking via turning knob
  • Optionally with lever lock (“child-proof”)
  • The running assemblies consist of four vertically arranged rollers
  • Low-noise, low-wear, heat and cold resistant running surfaces
  • Running assemblies pivot at any angle between 90° and 180°


  • Tongue and groove joint between the end caps
  • Brush seals are used horizontally at the top and bottom, at the inside and outside
  • Lower and upper brush gaskets are attached to the panel frames and not to the guide track
  • 10, and 12 mm tempered safety glass panes (ESG-H)
  • Panes width of up to 15 mm is possible
  • Panes secured via concealed screw-fixing system in top and bottom panel profiles  
  • Subsequent replacement of panes without difficulty
  • Subsequent replacement of panels without difficulty
  • Unpressurised drainage via inclined floor construction
  • Integrated water drainage channel on inside of bottom track
  • End-caps for lateral sealing of bottom track

You can choose from a large number of colours on the SUNFLEX colour wheel.


Resistance to wind load class A4 according to EN 12210 (Typ I)